Probe Editor
The Probe Editor is used to define data collection requirements prior to executing a simulation. Because most simulation models would generate very large volumes of data if all possible outputs were recorded, Modeler relies on the user to explicitly designate what is of interest. Each desired output is enabled by creating an object called a probe and configuring it appropriately. Groups of probes are saved as probe lists so that they can be used collectively when running simulations. Several types of probes are used to collect different types of simulation results. This section describes each type of probe.
Probe Editor Objects
Each probe is represented as an individual object. The probe’s attributes provide access to optional aspects of data collection, depending on the type of data. The following table lists each type of probe.
Table 15: Probe Editor Objects
| Probe Type | Definition | Representation |
|---|---|---|
| Node statistic | Applies to a node object at the network level, or to a module within a node. In both cases, the source of the statistic is a module, but as mentioned earlier, module statistics may be promoted to the node level. Supports collection of both built-in and user-defined statistics. | ![]() |
| Link statistic | Applies to a link object at the network level. Links generate only built-in statistics (computed by Modeler). | ![]() |
| Global statistic | Collects statistic values from multiple objects located anywhere in the network. The name of the statistic serves as a “rendezvous” point for the sources. | ![]() |
| Simulation attribute | Records a scalar statistic for the simulation attribute. Simulation attributes are viewed as input parameters of the system. Their values, while known in advance, are often needed in post-simulation analysis so that they can be related to simulation outputs. | ![]() |
| Automatic animation | Provides no-programming animation for several aspects of system behavior, including: packet flows at network and node level; node movement at network level; and state transitions for a process. | ![]() |
| Custom animation | Enables custom animation programmed within process models and link models. | ![]() |
| Statistic animation | Provides no-programming animation depicting statistics as they evolve during simulation. Statistics are presented as graphs in analysis panels, identical to the representation provided by the Results Browser. Axes rescale automatically to track changes. | ![]() |
For detailed information about probes, see Chapter 10 “Simulation Design” on page 375.






