ODB Command Reference

In addition to GUI operations, the ODB interpreter accepts commands from the Simulation Console or standard input device. It responds to these commands with output information printed to the Simulation Console or standard output device.

An ODB command consists of a single command word, followed by a list of arguments. ODB command names consist of one or more characters. However, they can be recognized by the interpreter if a sufficiently unique initial substring of the command name is specified; thus, the command fulltrace can be abbreviated as full, and the command next can be reduced to n.

You can enter one or more ODB commands per line (lines are delimited by a carriage return). Multiple commands on a line must be separated by a semicolon (";"). When there are multiple commands, ODB executes them in sequence and without pause. For example:

ODB> protrace 17;prostop 17 stream

   [protrace output]

<Next odb command> prostop 17 stream

   [prostop output]

Note: Commands that cause the simulation to resume running (next and continue) terminate a command line. Any subsequent commands on the same line are ignored.