Importing Dual MultiLayer Switch Feature Cards
NetPlanner supports Cisco 6500 series multi-layer switches with dual Multilayer Switch Feature Cards (MSFC). These devices are imported into the network model as multi-module switches, as shown in the following figure.
Figure 88: Multi-Module Switch in Network Model

Support for Cisco Catalyst 6500 multi-layer switches with dual Multilayer Switch Feature Cards (MSFCs) is enhanced for Device Configuration Import (DCI), Virtual Network Environment Server (NetCollector), Discrete Event Simulation (DES), and Flow Analysis. These multi-layer switches are imported as a multi-module switch type device and are used in DES and Flow Analysis.
Table 16: Command Support for Dual MSFC Devices
| Command | Importance | Usefulness |
|---|---|---|
show module |
Required on switches with Native IOS and on supervisor engines for switches with Hybrid OS | DCI uses the output from this command to determine the presence and serial numbers of MSFCs. |
show version |
Required on supervisor engine and MSFC(s) for switches with Hybrid OS | DCI uses the serial number from the output of this command to correlate the MSFCs to the switch. |
show redundancy |
Required for MSFC(s) for switches with Hybrid OS | DCI uses the output from this command to determine which of two MSFCs is designated. |
Redundancy information and configuration attributes of the non-designated MSFC in the dual configuration are now stored in the new MSFC compound attribute.
This section has the following subsections: