Analysis and Simulations of Cisco Firewalls
When you have Cisco firewalls in the network model, you can perform security audits and run simulations that let you assess the integrity of your network policies. Some of the questions you might want to answer with analysis and simulations are
- How secure is my network?
- Is my firewall effective in blocking the access I want to block?
- Is routing through my firewall working as expected?
Use the following to help you answer those questions and more:
Simulations
You can use discrete event simulation to perform studies on the security of your network model. The following support is provided for Cisco firewalls:
- Filters are supported and are defined under Security > Firewall Parameters > Access List Configuration
- Object groups in filters are supported and are defined under Security > Firewall Parameters > Object Group Configuration Aliases.
- Security levels for filters are defined under Security > Firewall Parameters > Interface Information
- Anti-Spoof Check, configured under Security > Firewall Parameters > Interface Information
- Network Address Translation (NAT), configured under IP > NAT Parameters. Dynamic, static, and identity NAT are all supported.
- Support for both routed and transparent modes
- Support for the use of address pools in NAT
- (DES) Translation idle duration, specified under Security > Firewall Parameters > Connection Configuration > Maximum Idle Durations
Note: Packets coming from low to high security levels must be explicitly permitted.
With these supported security configurations, you can conduct studies such as the following:
- Test to see if the security configuration is allowing and denying traffic in the expected manner
- Test to see if the NAT configuration works as expected
- Monitor the usage of dynamic NAT pools, and determine if traffic is blocked due to a lack of addresses.