Running Simulations with Dual MSFCs

You can run flow analysis on network models with dual MSFC switches imported through DCI or NetCollector. During import, you must have "config-sync" enabled. A dual MSFC switch is modeled as a single node with routing information from both MSFCs.

Flow analysis supports dual MSFCs with the following requirements:

  • MSFC failover in the network model is not supported; both MSFCs are assumed to be up or both MSFCs are down.
  • Routing simulates a network that has either both MSFCs running (with no failover) or both MSFCs down (device failure).

IP routing:

  • Both MSFCs can serve as sources/destinations to simulate:
    • ICMP (ping)
    • IP traffic flows

For HSRP:

  • One HSRP process runs on the device using the MSFC with the higher interface priority.

For BGP:

  • There is one incoming and one outgoing BGP connection on the designated MSFC for each BGP neighbor.
  • No BGP process runs on the non-designated MSFC.
  • The simulation uses the policies configured on the designated MSFC for both BGP neighbors.