Demand Menu Operations
This section contains descriptions and procedures for using the operations available from the Demand menu in the Demand Editor. The Demand menu operations include:
Model Attributes
This operation opens the Model Attributes dialog box, which allows you to create, edit and delete demand model attributes. Attributes are essentially “parameters” of the model, allowing users to control the model’s behavior in predefined ways. Demand attributes are automatically promoted to the network level, where they appear as attributes of demand objects.
Figure 218: Model Attributes Dialog Box

Attributes make demand models more robust and reusable. You can create an attribute to represent a particular characteristic of a demand, rather than “hard-wiring” that characteristic into the model. Users can then configure the attribute appropriately in each instance of the demand. Process models or pipeline stages may use different demand object attributes to simulate different model behaviors. Attributes also allow users to run multiple simulations and automatically sequence through scenarios that differ only in their attribute settings. For these reasons attributes are preferable to creating a large number of models, each of which represents a unique set of “parameter settings”.
For general information about demands and model attributes, see “Modeling Concepts”.
Local Statistics
This operation declares named statistics that can be selected in the Probe or Project Editors; then process models or pipeline stages can use these statistics to collect demand data during a simulation. Local statistics are scoped to each demand, so different demand models can maintain local statistics with the same name. These statistics vary over time and can support multiple probes.
This operation opens the Declare Local Statistics dialog box, which you can use to create, delete and modify local statistics. See “Global Statistics” on page 487 for a description of the fields in this dialog box.
Figure 219: Declare Local Demand Model Statistics Dialog Box

For more information about local statistics, see:
Self Description
This operation allows you to set the information about a demand that is used to match demand models to the objects defined in an imported topology. The self description specifies information such as what type of interfaces the demand supports.
Figure 220: Demand Self Description Dialog Box

A self description has three basic parts:
-
Characteristics used for matching – These specify the demand model characteristics that is used to match against the characteristics of demands in an imported topology. Each characteristic has a value and a comparator. The comparator specifies what relationship must exist between the values of a characteristic for the demand model and a demand in the imported topology for a match to occur, as defined in the following table.
Table 112: Requirements Comparators
Comparator Meaning Equals The imported demand’s value must equal that of the demand model. One-of The imported demand’s value must equal one of the values listed for the demand model. Range The imported demand’s value must be in the range specified for the demand model. Contains The imported demand’s value must contain that of the demand model. -
Assignments – These specify attributes that will be assigned to the demand model when it is chosen to represent an imported demand.
-
Priority – During topology import, if more than one demand model that matches an imported demand is found, the model with the highest priority is used.
Procedure 215: Creating a Demand Self Description
-
Choose Demand > Self Description.
Result: The Self Description dialog box opens.
-
Specify requirements and assignments for the demand model.
-
Set the priority for the demand.
-
Click OK to close the Self Description dialog box.