Analyzing Network Models Containing Juniper SRX Firewall

Support is included for running Flow Analysis against imported network models that include SRX firewalls. You can also determine if traffic is taking the route you expect by showing routes between selected nodes. This section describes a few tools you can use when analyzing your network model.

Show Routes Between Selected Nodes for SRX Firewalls

To determine the path your traffic is taking in the model, you can use Show Routes Between Selected Nodes. Select two nodes in the model, and then choose Flow Analysis > Show Routes Between Selected Nodes... to open the Show Routes dialog box. This feature is particularly helpful when using and troubleshooting route-based VPNs.

For more information about this feature, see “Viewing Traffic Routes Between Two Selected Nodes“ on page 43.

Flow Analysis Reports for SRX Firewalls

Several reports are available in Flow Analysis that can provide information about routing, IP tunnels, and virtual routers configured in the model. This section describes the reports that are useful for analysis of your network model containing SRX firewalls.

Configuration > Virtual Routers

Virtual router configuration, including the associated router, security zones, and interfaces, are displayed in the Global > Configuration > Virtual Routers report.

Configuration > IP Tunnels

The IP Tunnels report displays tunnels that are configured in the network model along with source/destination information, tunnel mode, and tunnel name.

Configuration > IPv4 Static Routes

If static routes are configured in your network model, you can refer to the IPv4 Static Routes report.

Performance > IP Tunnel Routing

This report displays information about the source and destination of the tunnel as well as whether traffic was successfully routed over the tunnel.

Performance > Virtual Router Forwarding Tables

You can view the forwarding tables for a virtual router by right-clicking on the SRX device in the network model and expanding the Performance > Virtual Router tree. Note that source-based forwarding tables are available when this type of routing is enabled for the virtual router.

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com