Set Network Model
You may want to adapt the set of probes you created for one model to another model, perhaps a variant scenario in the same project. You do this by opening the source probe model and choosing the Set Network Model command to open the new network model. You then apply the existing probes to objects in the new model.
When you adapt a set of probes, you may find probes in the source list that apply to objects that don’t exist in the new model. It is good practice to remove these probes. However, when the simulation runs, the obsolete probes are not applied.
Procedure 230: Adapting an Existing Probe Model to a Different Network Model
-
Open the Probe Editor with the set of probes you intend to adapt.
Result: The Probe Editor appears.
-
Choose File > Save As… and save the set of probes with a new name.
-
Choose Objects > Set Network Model.
Result: A File Open dialog box appears, listing available network models.
-
Select the network model that requires probes.
Result: The interface does not change.
-
Select a probe that you wish to apply to the newly-set network model.
Result: The probe is highlighted.
-
Select Choose Probed Object from the Probe Editor pop-up menu.
Result: The Network Browser appears.
-
Select the object-of-interest from either the treeview list or the graphical representation and click OK.
Result: The object name appears in the Object column and the Network Browser closes.
-
Delete unused probes by selecting the probe and choosing Edit > Cut.
-
Save the adapted probe model.