Model Architecture: ATM
Figure 110 illustrates the underlying architecture of the atm_wkstn node model. Notice the three different layers reflecting the Application layer over IP over ATM architecture that characterizes the atm_wkstn model.
Figure 110: Architecture of the atm_wkstn Node Model

The following table lists the process models used by the ATM model suite.
Table 21: ATM Process Models
| AAL Module | |
ams_aal1_conn_v3 |
Implements the encapsulation and decapsulation of SAR_PDUs following the AAL1 protocol. |
ams_aal2_conn_v3 |
Implements the encapsulation and decapsulation of SAR_PDUs following the AAL2 protocol. |
ams_aal34_conn_v3 |
Implements the encapsulation and decapsulation of SAR_PDUs following the AAL3/4 protocol. |
ams_aal5_conn_v3 |
Implements the encapsulation and decapsulation of SAR_PDUs following the AAL5 protocol. |
ams_aal_disp_v3 |
Root process of the AAL module. It creates and invokes signaling and connection processes to handle new connections, incoming signals and data. |
ams_aal_sscop |
Performs reliable transfer of SAAL messages for each signaling connection |
| ATM_call_control Module | |
ams_atm_call_control |
Accesses interfaces between the data plane and the control plane. |
| ATM_sig Module | |
ams_atm_call_dst_v3 |
Handles signaling to establish and release an ATM connection at the called (i.e., destination) node. |
ams_atm_call_net_v3 |
Handles signaling to establish and release an ATM connection at a node that is neither the calling nor the called (i.e., network) node. |
ams_atm_call_src_v3 |
Handles signaling to establish and release an ATM connection at the calling (i.e., source) node. |
ams_atm_signaling |
Handles all signaling to establish an ATM connection |
| ATM_rte Module | |
ams_atm_dr |
Builds and updates ATM routing table; provides route recommendations to other ATM processes. |
| ATM Layer Module | |
ams_atm_layer_v3 |
Encapsulates and forwards data from the AAL layer; decapsulates and forwards data to the AAL layer; forwards cells from the ATM Management module. |
| ATM Switch Module | |
ams_atm_sw_v3 |
Switches cells to output ports. It also implements buffer management, based on QoS and the ABR feedback mechanism. |
| ATM Translation Module | |
ams_atm_trans_v3 |
Receives incoming ATM cells from network; translates VPI/VCI values for outgoing cells; forwards cells to appropriate ATM module. |
| IPAL Module | |
ams_ipif_v4 |
Transports IP datagrams across the ATM network; establishes and releases AAL connections, as required. |
| traf_src Module | |
ams_traf_gen_v3 |
Initiates call start and end, generates the actual packets, and sends them to the AAL module. |
| traf_srct Module | |
ams_traf_sink_v3 |
Acts as the final destination for the data packets. |