Discrete Event Simulation Attributes
Simulation attributes can be used to reduce the discrete event simulation run time duration. By enabling one or more of the simulation attributes, you can reduce the amount of time needed for the simulation to run, without sacrificing the accuracy of your results.
The ATM simulation attributes are described below:
ATM Address Information Export. This attribute defaults to Do Not Export. In the simulation configuration, you can set the value to Export. This attribute is used to obtain the ATM address of all nodes in the network, as well as PNNI level and ID information. The resulting file has the following name format: <project>-<scenario>-atm_addresses.gdf
ATM Dynamic Routing Protocol. This simulation attribute determines the routing protocol used by the ATM switches. When this simulation attribute is set to Distance Vector, all switches in the network use the Distance Vector Routing Protocol, as described in the Switch Attributes section. Using the Fast-Mode PNNI setting reduces simulation run time by using the static PNNI routing protocol whereas using the Explicit-Mode PNNI would run the full blown PNNI routing protocol on all nodes.
ATM SSCOP Sim Efficiency Mode. When this simulation attribute is set to enabled, the IDLE timer is set to infinity. The IDLE timer is started when there is no outstanding data waiting to be acknowledged or any pending data to be transmitted. When data traffic begins, the SSCOP process transitions from the IDLE phase to the active phase. When this simulation attribute is enabled, the SSCOP process will not be able to detect link or node failures when there is no data traffic between the peer processes. Therefore, you should disable this attribute if you are studying node and link failures.
ATM Sim Efficiency. When this simulation attribute is set to Enabled, cells are delivered directly to the destination nodes and are not transmitted via the link pipeline stages. Propagation and transmission delays are computed internally. This efficiency attribute increases simulation speed by reducing the total number of events. Note that you cannot collect link utilization and throughput statistics if this efficiency mode is enabled.
compound_cell_enabled. When this simulation attribute is set to enabled, packets are sent into the ATM network without being segmented into cells. However, overheads and segmentation delays are computed. Although this efficiency mode affects the value of statistics monitored at the ATM layer (such as cell delay, cell loss ratio, and cell delay variation), statistics monitored at higher layers are unaffected.