APS
Automatic Protection Switching (APS) allows switchover of Packet-over-SONET (POS) circuits in the event of circuit failure and is often required when connecting SONET equipment to telco equipment. APS uses protect POS interfaces in the SONET network as backups for working POS interfaces. When a working interface fails, its protect interface quickly assumes its traffic load. The protection mechanism has a “1+1” architecture, whereby a protect interface is paired with each working interface. The two circuits can be configured to terminate on the same router or on different routers.
The model supports APS for IP router interfaces only and accounts for the APS behavior due to the following types of failures:
- Interface failures
- Router failures
- Failures of the links that connect to the telco equipment (usually an Add-Drop Multiplexer (ADM)
The following use cases are supported for networks that use APS:
- Importing APS configuration details and current operational status information from NetCollector
- Visualizing APS configuration and operational status in the Project Editor
- Analyzing the survivability of APS-enabled networks
Table 17: Summary of APS Support in Riverbed Modeler
| Technology | Supports APS | Special Requirements |
|---|---|---|
| Device Configuration Import | No | |
| Import from NetCollector | Yes | None |
| Discrete event simulation | No |
Topics covered: