IGMP Snooping
IGMP snooping is supported for IPv4 multicast traffic. IGMP snooping is a process in which a switch listens to IGMP multicast conversations and IGMP membership reports, then filters the traffic based on group membership. Multicast traffic is delivered only to the end systems that have explicitly joined a multicast group.
Figure 225: IGMP Snooping Example

Note: IGMP snooping is supported for discrete event simulation only.
The following features are implemented:
- Snooping of IGMP packets
- Filtered forwarding of IGMP Membership Reports only to ports on which IGMP routers are connected
- Forwarding of IPv4 multicast traffic based on group membership tables, which are also VLAN specific in VLAN-aware switches, that map the multicast group MAC addresses to the MAC address of the end systems
- Updating of group membership tables after a topology change
- Group membership timeout
To configure IGMP snooping, configure the compound attribute shown in the figure below—Bridge Parameters > IGMP Snooping Parameters—on each switch for which you want to enable snooping. In this attribute, you can enable or disable IGMP snooping and can set the group membership timeout. The group membership timeout is a value (in seconds) after which, if an IGMP Group Membership Report has not been received from a host, the switch deletes the host from the group membership table and ceases to forward IPv4 multicast traffic to that host.
Figure 226: IGMP Snooping Attributes

Note: Multicast Listener Discovery (MLD) snooping is not currently supported.