Model Features: IP Multicast

The IP Multicast model supports the following protocol features.

Table 113: IP Multicast Model Features

Feature Description
Rendezvous Point (RP) Selection The model supports dynamic and static RP selection. Two types of dynamic RP selection are supported: Bootstrap and Auto-RP. Auto-RP is feature of Cisco routers, which is automatically supported on all Cisco router models.
Anycast RP Anycast RP uses PIM-SM and the Multicast Source Discovery Protocol (MSDP) to allow multicasting via multiple RPs or across domains. This permits failover and load balancing among the RPs in a multicast group.
Shortest Path Tree (SPT) Switchover Multicast routing uses the PIM-SM (Protocol-Independent Multicast - Sparse Mode) multicast routing protocol. The operation mode can be changed from shared-tree (RP tree) to shortest path tree (SPT tree) dynamically (during a simulation).
Source Specific Multicast (SSM) SSM is a method of delivering multicast packets in which the packets that are delivered to a receiver are those originating from a specific source address requested by the receiver. By so limiting the source, SSM reduces demands on the network resources and improves security. SSM requires IGMPv3.
IGMPv3 IGMPv3 adds support for the source filtering that is required for Source Specific Multicast (SSM). Using IGMPv3, a system can specify a source address from which to receive or not receive certain multicast traffic.
Capacity Planning The model supports capacity planning studies using flow analysis and the Capacity Planning module.
Traffic Engineering Use the IP multicast model for the following types of traffic engineering studies:
- Dependency on RP Position
- Dependency on Multicast Routing Configuration
- Dependency on Static Routing Configuration
- Dependency on Unicast Routing Table
Message Priority You can set the priority of IGMP messages exchanged in the entire network by specifying the DSCP marking of the messages using the corresponding global attribute. The default value is CS6.
The priority of PIM-SM messages can be set similarly using the corresponding global attribute. This setting covers all PIM-SM messages except registration messages. For registration messages, priority is set based on the priority of the data they are carrying.

Table 114: Summary of IP Multicast Support in Riverbed Modeler

Technology Supports IP Multicast Special Requirements
Device Configuration Import ✔
Import from NetCollector ✔
Virtual Network Interface ✔
NetDoctor
Flow analysis
Discrete event simulation ✔ Simulates PIM -Sparse Mode only. Does not support PIM - Sparse-Dense Mode, PIM Dense Mode, SSM, and IGMPv3.