Local Group-to-RP Table

Local RP information is stored in a group-to-RP mapping table. This table contains RP information used by individual routers. It is based on Static, Auto-RP, and Bootstrap configuration. The table can be viewed after running the simulation in discrete event simulation.

Procedure 49: Viewing the Local Group-to-RP Table

  1. Configure RPs and select “IP Multicast Group-to-RP table” report (shown in Figure 220 and Figure 221).

    Figure 220: Exporting IP Multicast Reports

    Exporting IP Multicast Reports

  2. Run a discrete event simulation.

  3. View the table using View Results > Discrete Event Tables > Configuration > IP Multicast RP Configuration.

    Figure 221: PIM-SM Routing Table Report and Group-to-RP Table Report

    PIM-SM Routing Table Report and Group-to-RP Table Report

    Note: The discrete event simulation creates group-to-RP mapping only once at the beginning of the simulation. As a result, the table does not change with time and it can thus be exported only at the end of the simulation.

End of Procedure 49