LDP-Based VPLS and Layer-2 VPNs

LDP-based VPLS and Layer-2 VPNs use LDP as the auto-discovery and signaling protocol. The PE routers should have Layer-2 and Layer-3 modules. Customer Edge routers (CE) should connect to the Layer-2 module of the PE routers. The procedures for creating a tunnel LSP between PE routers and for configuring an IGP on PE and P routers are the same as for BGP-Based VPLS and Layer-2 VPNs. Refer to Procedure 91 and Procedure 92 for details.

Configuring Layer-2 VPNs

This section describes how to configure LDP-based Layer-2 VPNs. The first step in this process is to configure Layer-2 forwarding equivalence classes (FECs) on the PE routers

Procedure 95: Configuring Layer-2 FECs on PE Routers

  1. Create a FEC for each customer in the VPN > Network Based > L2VPN/VPLS Instances > LDP Based > Layer-2 FECs attribute. You can use the VLAN ID, port, or both as the FEC.

  2. Configure the remote peer in the Remote Peer Configuration attribute. Make sure that the VC ID and the Group ID match the Layer-2 FEC configuration.

  3. If you are using VLAN ID as the FEC, configure the VLAN on the PE router.

    • Create an entry for the VLAN in the VLAN Parameters > Supported VLANs.
    • Map the VLAN to the ports by configuring Switch Port Configuration > VLAN Parameters.

End of Procedure 95

Configuring VPLS

This section describes the specific configuration for LDP-based VPLS. To do this, you must configure VPLS Profiles on the PE routers.

Procedure 96: Configuring VPLS

  1. Create an entry for a VPLS profile for each customer in the VPN > Network Based > L2VPN/VPLS Instances > LDP Based > VPLS Profiles attribute.

  2. Configure the Customer ID, VLAN IDs and the Port List.

  3. Specify the remote peers and their associated VC properties in the Remote Peer Configuration attribute. Make sure that the VC ID and the Group ID match the Layer-2 FEC configuration.

  4. If you are using VLANs, configure the VLAN on the PE router.

    • Create an entry for the VLAN in the VLAN Parameters > Supported VLANs attribute.
    • Map the VLAN to the ports by configuring the Switch Port Configuration > VLAN Parameters attribute.

End of Procedure 96

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com