MPLS for Traffic Engineering Studies

The MPLS model can be used for traffic engineering studies. You can configure MPLS automatically by importing the network configuration using the device configuration import or import from NetCollector features. This section describes how to manually configure MPLS for traffic engineering studies. The following topics are covered

  • Configuring Label-Switched Paths (LSPs)
  • Defining how traffic is assigned to LSPs

Before LSPs are configured, the network devices should have MPLS enabled and should be running OSPF or IS-IS as a routing protocol. To enable MPLS on routers select Protocol > MPLS > Configure Interface Status. All interfaces should have OSPF or IS-IS enabled. OSPF and IS-IS are link state routing protocols that support extensions for traffic engineering.

Routers that are the source or destination of an LSPs must have a loopback interface that is reachable from other sections of the MPLS domain.