BGP Configuration
Some additional BGP configuration is needed when setting up Layer-3 VPNs. Send communities must be enabled for Layer-3 VPNs to work. Additional configuration is also needed to accommodate the different address families that exist in the network.
BGP configuration is per address family. Layer-3 VPNs need both an IPv4/IPv6 address family and a VPNv4/VPNv6 address family. Any VRFs that are configured also need a separate BGP configuration. Each address family is configured by adding a row to the BGP Parameters table, shown below.
Figure 396: BGP Configuration for Layer-3 VPNs

If the VRFs are configured to use BGP, you must set up the BGP neighbor relationships as described in "BGP". If the VRFs use another routing protocol, you need to configure redistribution between that routing protocol and BGP.