MPLS Configuration

There are two ways to create LSPs when analyzing Layer-3 VPNs. The LSPs can be LDP-based paths, or you can create traffic engineered LSPs manually. Each method is described below.

LDP-Based Paths

To use this method, you need to enable LDP for all routers and router interfaces running LDP. Make sure that the following settings are configured:

  • MPLS > LDP Parameters > Status attribute enabled on all routers
  • MPLS > LDP Parameters > Interface Information > Status attribute enabled for all interfaces

For an LDP-based path, the local LSR, on which LDP is enabled, finds other LDP-enabled devices through the use of a Hello protocol. The LDP-enabled devices form adjacencies by negotiating operational parameters. Eventually, these adjacent routers participate in the LSP, and the LSPs follow the IGP path through the network.

Dynamic/Static LSPs

You can also use dynamic or static LSPs for your Layer-3 VPN analysis. See Procedure 78, Procedure 79, and Procedure 80, for information on manually creating dynamic and static LSPs.

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com