Admission Control

The admission control procedure is executed by each eNodeB for its cell. All requests for GBR radio bearers go through admission control. When a GBR radio bearer is created, cell resources allocated for it is deducted from available cell resources. Similarly, when such a bearer is released, its resources are added back to the common pool.

The admission control procedure admits a GBR radio bearer only if it is possible to allocate requested resources for that bearer in the cell for both the uplink and downlink direction. Being able to allocate resources in one direction only is not sufficient to admit the bearer.

The admission control procedure has the ability to start the preemption procedure for one or more low priority GBR radio bearers to be able to accept a radio bearer request for a high priority EPS bearer.

  • The relative priority of radio bearers is decided based on the value of the ARP parameter of their EPS bearers (lower numerical ARP value means higher priority).
  • Preemption does not happen for any radio bearer if there are not enough resources to admit the new bearer even after preempting all the low priority bearers.
  • Preemption procedure first creates an initial preemption list of bearers. It starts adding the bearers that have the lowest priority to this list and stops when there are sufficient free resources to admit the new bearer when the resources coming from bearers preempted up to that point are taken into account. In some cases, the resources coming from bearers preempted up to this point might be more than necessary and it might be possible to avoid the preemption of some bearers. Therefore, once the initial preemption list is prepared, the preemption procedure will always execute a second pass through the list to minimize the number of preempted bearers. During this pass, starting from the higher priority bearers (excluding the last one added), bearers are removed from the list if there will still be sufficient resources in the cell to admit the new bearer, even when that bearer is not preempted and all the ones that are still in the list are preempted.
  • The accept response is sent to the requesting entity without waiting for the completion of preemption procedures, if any are triggered by the radio bearer creation request.

While computing the frame capacity (i.e., initially available amount of cell resources), admission control procedure takes the following overheads into account:

  • Downlink
    • Downlink reference symbols – Four resource elements per RB
    • PDCCH (downlink L1/L2 control channel) – The size of PDCCH for admission control purposes is configurable via an eNodeB attribute
  • Uplink
    • Uplink reference symbols – 12 resource elements per RB
    • PUCCH (uplink L1/L2 control channel – The size of PUCCH is obtained from eNodeB's PUCCH configuration attribute
    • PRACH – 12 RBs per random access resource, where the number of RA resources per frame depends on the configuration of the random access parameters of eNodeB

Oversubscription and undersubscription are allowed. You can enable this by configuring the loading factor attribute at eNodeBs. Setting this attribute to "No Admission Control" disables the admission control for the cell of that eNodeB. An admission control report table is created at the end of the simulation.

An estimated frame capacity report table is created, shown in Figure 343.

  • This table is created for both uplink and downlink. Estimated capacity is reported for a subset of MCS index values. The table has two rows:
    • The first row is the raw estimated capacity for each of the selected MCS index values. The estimated capacity is computed by assuming a single UE saturating the channel.
    • The second row reports the estimated channel capacity used by the admission control, which also takes the loading factor into account