Radio Link Control (RLC)

Segmentation and concatenation procedures are performed using a dynamic PDU size that is determined by the scheduler decisions (allocation sizes) based on the subframe capacity and relative priorities of the radio bearers with non-empty transmission queues.

The model supports the following RLC modes:

  • Transparent mode – No RLC header is included in this mode.
  • Unacknowledged mode – This mode ensures in-sequence delivery of SDUs to the higher layers.
  • Acknowledged mode – This mode ensures retransmission of missing SDUs in addition to in-sequence delivery of SDUs to the higher layers.
    • While transmitting PDUs, an RLC entity in acknowledged mode follows this priority order: status report PDU > retransmitted PDU(s) > PDU with new data
    • Upon successful delivery of higher layer PDUs, an indication is sent to the PDCP layer
    • Upon reaching the retransmission threshold, an indication is sent to the higher layer
    • While retransmitting RLC AMD PDUs, segmentation of the retransmitted PDUs in cases of small maximum allowed PDU sizes is supported

RLC parameters specified in 3GPP TS 36.322 are configurable in the attribute LTE > EPS Bearer Configurations > Radio Bearer RLC Configuration.

Signaling radio bearers (SRBs) use RLC acknowledged mode (AM). The RLC mode of the data radio bearers is configurable separately for uplink and downlink, and the selection is between unacknowledged mode (UM) and AM, with the exception that the Default bearer always uses UM. Only CCCH transmissions use transparent mode, and all CCCH transmissions use this mode.

The model supports the RLC re-establishment procedure as specified in section 5.4 of 3GPP TS 36.322.