Visualizing Congestion Areas

There are several ways to view information about congested areas in the network when using discrete event simulation.

Results Viewer Table

Reports are available in the Results Viewer that provide detailed information about congestion in the network. To enable these reports, place a "Background Traffic Config" object (from the Utilities object palette) in the network and set the Congestion Areas > Congestion Area Analysis attribute to be Enabled.

Route Browser

After enabling the Congestion Areas.Visualize Congestion Areas in the Bgutil Config node and running DES with Route Recording enabled on your IP demands, you can visualize congestion in the project editor workspace using the Protocols > IP > Demands > Display Routes for Configured Demands utility.

Time Controller Visualization

After enabling the Congestion Areas.Visualize Congestion Areas in the Bgutil Config node and running DES, and visualizing them with the Protocols > IP > Demands > Display Routes for Configured Demands utility, you can use the Time Controller to animate the visualization and see how the congestion varies with time. Congestion is shown as a utilization violation (UV), or as multiple violations (MV) if there are also number-of-flows violations at the same time (FV).

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com