Defining an Antenna Pattern Graphically

You can draw an antenna pattern in the rectangular view of the Antenna Pattern Editor. This view is displayed when the Polar Plane Section tab is selected (see Rectangular Plot for details). In the rectangular view, you draw gain curves for one polar plane of the pattern at a time.

Drawing an antenna pattern is a good way to quickly get an approximate pattern for simulations. If you need a more precise pattern, you can define it numerically (Defining an Antenna Pattern Numerically) or use an external library (Defining an Antenna Pattern via an External Library).

Procedure 30: Creating an Antenna Pattern Table Graphically

  1. Choose File > New… and select Antenna Pattern from the pull-down menu.

    An Antenna Pattern Editor window opens.By default, the Polar Plane Section tab is selected, displaying a rectangular plot of the plane at polar = 90° (the x-y plane).

  2. Set the resolution you want to use for the antenna pattern model. By default, the model divides the pattern into 36 polar planes and 72 azimuth values per polar plane. See Specifying the Resolution of an Antenna Pattern for details.

  3. If you want to define a different plane than the one displayed, do one of the following:

    • Select the desired plane from the “Polar plane” pull-down menu.
    • Use the Increase Polar Plane (Ctrl+<down-arrow>) or Decrease Polar Plane (Ctrl+<up-arrow>) command on the Antenna menu to step through the planes to the one you want.
    • Choose Increase Polar Plane or Decrease Polar Plane from the Antenna pop-up menu.

    The editor redraws the display to show the graph for the selected polar plane.

  4. In the rectangular plot, draw a line graph representing gain as a function of azimuth for the selected polar plane. For details about how to draw a line graph, see Editing a Line Graph.

    If desired, you can open a Polar (Radial) Plot or 3D View to watch what effect your changes have on the antenna pattern.

    If you need a larger range of gains, use the Set Ordinate Upper Bound and Set Ordinate Lower Bound operations (Setting the Ordinate Bounds) to set the upper and lower gain values in the plot to any positive or negative integer values.

  5. If desired, use the Smooth operation (Smoothing an Antenna Pattern) to round out sharp edges in the current polar plane.

  6. Typically, a complete antenna pattern requires specifying multiple planes (that is, drawing antenna gain curves for multiple polar values). Define additional planes by repeating step 3 to step 5.

    Note: When editing adjacent planes, it is easiest to change planes with the Increase Polar Plane (Ctrl+<down-arrow>) and Decrease Polar Plane (Ctrl+<up-arrow>) commands. These operations shift the graph to the next adjacent plane.

  7. If desired, use the Normalize operation (Normalizing an Antenna Pattern) to adjust the entire gain table (all planes) for a net 0 dB gain over all directions.

  8. Choose File > Save or File > Save As… to save the antenna pattern model.