Default Models

This section contains detailed descriptions of the Radio Transceiver Pipeline default models supplied with Riverbed Modeler.

Riverbed Modeler supports dynamic modeling of radio links between communication nodes. The characteristics and availability of these links can be subject to time varying factors such as the mobility of communication nodes, the modification of transmitter and receiver attributes, and the interference of other concurrent transmissions.

The Simulation Kernel relies on a 14-stage computational pipeline to evaluate the characteristics of radio communication when transmissions occur. Default procedures are provided to occupy each stage of the pipeline. These are intended to be useful for a variety of common radio situations, and can be replaced by user-supplied procedures for other cases.

Table 67: Radio Transceiver Pipeline Default Stages

Pipeline Stage Attribute Name Default Stage Name
0: Receiver Group rxgroup model dra_rxgroup
dra_rxgroup_no_rxstate ¹
1: Transmission Delay txdel model dra_txdel
2: Link Closure closure model dra_closure
3: Channel Match chanmatch model dra_chanmatch
4: Transmitter Antenna Gain tagain model dra_tagain
5: Propagation Delay propdel model dra_propdel
6: Receiver Antenna Gain ragain model dra_ragain
7: Received Power power model dra_power
dra_power_no_rxstate ¹
8: Interference Noise inoise model dra_inoise
9: Background Noise bkgnoise model dra_bkgnoise
10: Signal-to-Noise Ratio snr model dra_snr
11: Bit Error Rate ber model dra_ber
12: Error Allocation error model dra_error
13: Error Correction ecc model dra_ecc
dra_ecc_no_rxstate ¹

Note 1: These stages can be used as defaults if no receiver channel state information is used.