Model Limitations: Wireless LAN

The following protocol features are not included in the WLAN model.

  • PCF on noisy links—WLAN PCF does not work properly on noisy links or when the communication is lost with AP.
  • FHSS and IR PHY—Modulations used by FHSS and IR PHYs are not modeled.
  • Background traffic
  • Modulation of PLCP—The same modulation is applied both to the PLCP preamble and header, and to the rest of the frame based on the data rate used for the transmission of the frame. In other words, when necessary, PLCP overhead’s transmission is modeled at a lower transmission rate, but the bit error rate is computed based on the data rate of the rest of the packet.
  • Management frames—With the exception of beacons and Block-ACK related action management frames, management frames are not modeled. Transmission of periodic beacons in ad-hoc WLANs is not modeled.
  • Power save mode
  • Authentication and security procedures
  • Variable transmission rate—The transmission rate used for data transmission by a WLAN node is static throughout the simulation.
  • Failure and recovery—Node failure/recovery is not supported.
  • Full 11e support. The following 11e features are not modeled: HCF Controlled Channel Access (HCCA), and Direct Link Protocol (DLP).
  • IEEE 802.11n features such as Phased Coexistence Operation, LSIG TXOP protection, and Reverse Direction Protocol are not implemented.
  • OBSS (Overlapping Basic Service Set) scanning for 40MHz-capable HT STAs is not supported.
  • The physical layer effects of having multiple spatial streams (MIMO) are not modeled.
  • During 802.11p operation, A-MSDUs and A-MPDUs are not supported.
  • Layer-2 WDSs—Only Layer-3 wireless distribution systems (WDS) are supported, Layer-2 WDSs are not supported.
  • Roaming and PCF. Both of these features are implemented separately, but they cannot be used together.