General Workflow for Device Configuration Imports
The general workflow to generate a topology is as follows:
-
Create the device configuration files for the routers, Cisco PIX devices, and switches you want to import.
-
Import the device configurations into NetPlanner.
-
Specify missing interface, port, or link information such as data rate and unnumbered interface information. DCI includes an Import Assistant for you to specify this information.
For more information, see Using the Interface Assistant.
To include supplemental information that is not in the configuration files, you can apply model assistant files during or after the import. For more information on Model Assistant files, refer to “Model Assistant“. You can also do a partial or incremental import to add new devices to the topology or to update devices already in the topology.
After the network is generated and fully configured, you can run simulation studies, using discrete event simulation or Flow Analysis, or validation studies using NetDoctor.
The following references point to sections of this document that describe each step in detail.
- Preparing for the Import:
- Includes directory and file creation, creating device models, and setting import preferences
- Troubleshooting the Import
- Includes information on common import issues and how to avoid them
- Performing an Import with DCI
- Using the Interface Assistant
- Viewing the Import Summary Report
- Using Model Assistant Files with Imported Topologies
- After the Import
- Includes information about generating reports and managing the network model