Device Configuration Imports (DCI)

DCI lets you generate a network model by importing configuration data for

  • Juniper JUNOS
  • Cisco IOS
  • Cisco PIX firewalls
  • Cisco Catalyst switches

DCI uses the data in the configuration files to set the NetPlanner attributes that control routing and switching behavior, including

  • System information including DRAM, NVRAM, Flash RAM, operating system type and version, serial number, and module name

    Note: Memory information is parsed from the “show version” command. Currently only Cisco devices provide this information through “show version”. Therefore, non-Cisco devices have the memory attributes set to “Unknown” during import.

  • Connections, data rates, and interfaces (including PVCs, aggregate interfaces, loopback interfaces, tunnel interfaces, VLANs, and sub-interfaces)

  • Protocol information for IP, IP Multicast, BGP, EIGRP, OSPF, RIP (versions 1 and 2), IGRP, IPX, Frame Relay, ATM, RSRB, DLSW, NAT, QoS, and VPLS

  • ACLs (access control lists), route maps, and Juniper firewall filters

  • Static routing, default routing, policy routing, and route redistribution

  • VLAN, VLAN trunking protocol (vtp), spanning tree, and bridge configuration information

  • Cisco security: AAA, TACACS+, Radius, Kerberos

DCI Import Topics

The DCI Import section contains the following subsections:

Supported Commands and Features

During import, NetPlanner considers and parses device configurations and translates these into model attributes. Currently, not all specific configuration commands and values are supported.

For information on the commands and features that are supported, see the Riverbed Support website.

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com