Dual-Stack Configuration

IPv4-Only, IPv6-Only and IPv4/IPv6 Node Configuration

Interfaces can be configured to support only IPv4, only IPv6, or both IPv4 and IPv6. You can use the Protocols > IP > IPv6 > Configure Interface Status menu operation to enable or disable IPv6 on all interfaces in the network or on the selected interfaces only.

To manually enable or disable IPv6 on interfaces, do the following.

  • To configure an interface to support IPv6 but not IPv4, set the IPv4 address of the interface to “No IP Address.”
  • To configure an interface to support IPv4 but not IPv6, set the link local address to “Not Active.”
  • To configure an interface to support both IPv4 and IPv6, configure IPv4 and IPv6 addresses on the interface. The IPv4 addresses can be left as Auto-Assigned.

Application Configuration

All of the standard network applications (such as FTP, HTTP, and Email) can also run on IPv6 nodes. No special configuration is needed for IPv6. The version of IP used for the application is determined as follows:

  • If both the client and the server are dual-stack nodes, the application uses the version specified in the IP Version Preference attribute. IP Version Preference is a simulation attribute, which is set to IPv6 by default.
  • Otherwise, the version of IP that is supported by both the nodes is used. If no such version is available the two nodes cannot talk to each other.

There is no way to specify which address is used if the node has multiple IPv6 addresses. The address is chosen according to the following rules:

  • For gateway nodes, the address of an IPv6-enabled loopback interface is used, if one is available.
  • On other nodes, the first global address of an interface is used.

Traffic Demand Configuration

You can configure traffic demands between two IPv6 interfaces or two IPv4 interfaces, but not between an IPv6 interface and an IPv4 interface. By default, the source and destination IP addresses for the traffic demand are auto-assigned. The version of IP used for the demand is determined as follows:

  • If both the client and the server are dual-stack nodes, the application uses the version specified in the IP Version Preference attribute. IP Version Preference is a simulation attribute, which is set to IPv6 by default.
  • Otherwise, the version of IP that is supported by both the nodes is used.

You can manually specify the source and destination interfaces of the traffic demand by editing the Source IP Address and Destination IP Address attributes of the traffic demand.

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com