Menu Operations

The Protocols > IP > IPv6 menu includes several operations to help you configure IPv6 in a network model.

Table 124: IPv6 Menu Operations

Menu Option Description
Auto-Assign IPv6 Addresses Enables IPv6 and assigns IPv6 global addresses to physical and loopback interfaces in the network that do not yet have an IPv6 global address. If no links are selected in the workspace, this operation assigns an IPv6 address to all of the connected interfaces in the network.
If you do not want to configure IPv6 addresses on all of the connected nodes, select the links connected to the interfaces you want to configure before selecting this menu operation.
Clear IPv6 Addresses Deletes the global and link-local IPv6 addresses configured on all interfaces (physical, loopback, VLAN, tunnel, aggregate, and sub -interfaces) in the network.
This operation also disables IPv6 on the affected interfaces by setting the link-local address to “Not Active.”
Assign IPv6 Addresses to Sub-Interfaces on Selected Nodes Uses the existing IPv4 address and mask to pick the IPv6 addresses. The IPv6 prefix is constructed from the IPv4 prefix, and the IPv6 host bits are constructed from the IPv4 host bits.
Can be used in situations where there is a v4 baseline with sub-interface configuration.
Configure IPv6 Routing Protocols… Launches a dialog box that will allow you to configure IPv6 routing protocols on specified interfaces. Any existing routing protocols configured on the specified interfaces will be updated based on the user selection.
Configure Interface Status… Lets you enable or disable IPv6 on all interfaces in the network or on the currently selected interfaces in the network.
Enable IPv6 on All Interfaces Configures all physical and loopback interfaces in the network to run IPv6. This is done by ensuring that the link-local address is set to a value other than “Not Active” for all interfaces in the network.
Disable IPv6 on All Interfaces Disables IPv6 functionality for all interfaces in the network. This is done by ensuring that the link-local address is set to “Not Active” for all interfaces in the network.
Create 6to4 Tunnels on Selected Nodes Creates a 6to4 tunnel, assigns it an IPv6 address, and creates a static route. This static route pushes all traffic destined to 2002::/16 onto the tunnel interface.
Run IPv6 Readiness Assessment... Launches the IPv6 Readiness Assessment, which helps you determine whether the equipment in the network can support IPv6, This option appears only when the IPv6 Planning and Operations module is enabled.
Run IPv6 Migration Planner… Launches the IPv6 Migration Planner, which helps you model full and partial IPv6 deployments. This option appears only when the IPv6 Planning and Operations module is enabled.
Clear IPv6 Configuration from Selected Nodes Removes any IPv6 settings from the nodes that are currently selected in the workspace.
Model User Guide Opens this document.