Network Address Translation - Traversal (NAT-T)

NAT-T provides a way for a HAIPE device residing behind a Network Address Translation (NAT) device to be able to establish SAs and communicate with other HAIPEs. During IKE, if a NAT device is detected between the HAIPE devices and NAT-T is enabled, the HAIPEs will exchange topology payload information and update their PEPTs accordingly. The responding HAIPE cannot be behind a NAT device, however; NAT-T will only work if the initiating HAIPE is the one behind a NAT. HAIPEs with NAT-T enabled should also enable PHRD to act as a keep-alive mechanism for the NAT session on the NAT device. The NAT-T configuration attributes are defined in the table below.

Table 87: NAT-T Attributes

Attribute Description
Status Specifies whether NAT-T is enabled for this HAIPE.
Topology Update Timers Specifies timeouts for sending Topology Update messages.

Note: HAIPEs behind NATs should not register with GDC because they would not be registered with a reachable address.

IKE Parameters

The IKE Parameters allow the user to configure all behavioral aspects of the IKE protocol that are not specific to any particular IKE version (i.e., HAIPE IKE). This attribute is also used to enable and disable the IKE protocol as well as specify which versions of the protocol are supported on the HAIPE device. If the protocol is disabled then even if the HAIPE is properly configured for IKE, the IKE protocol will not be able to operate. Additionally, the version of IKE configured within HAIPE Parameters must also be configured as a supported version within IKE Parameters otherwise the IKE protocol will not be able to operate.

All timers associated with the protocol are specified here as well. Changes made to the timers will affect the behavior of all IKE exchanges regardless of version being used.