Simulation Attributes

Simulation attributes apply to all nodes in the network topology. By enabling one or more of the SRP simulation attributes, you can reduce the amount of time needed for the simulation to run, without sacrificing accuracy.

The SRP simulation attributes, which are accessible from the Configure Simulation dialog box, are described below.

Figure 538: SRP Simulation Attributes

SRP Simulation Attributes

  • SRP Decay Interval Processing Mode: This attribute specifies if decay interval processing is explicitly simulated. When set to Efficient, control packets carrying usage information are not sent unless the usage information has changed. This attribute should be set to Explicit if one of the objectives of the simulation is to study the volume of control traffic flow. The results obtained with the different modes will differ because of the reduced control traffic in the Efficient mode.
  • SRP Topology Discovery Stop Time: This attribute specifies a time, in seconds, after which topology discovery packets are no longer sent. This is provided to allow faster simulation execution by assuming that the topology information does not change during the simulation and that modeling topology discovery traffic is not one of the objectives of the simulation.