Dynamic Ring Selection

Data transmission between a given source-destination pair takes place on one of the two available rings. Before data packets are transmitted, ARP is used to select one of the rings for data transmission and the other ring is then used to transmit control packets. The ARP and ring selection procedure used in the simulation model is described below.

  • The source node performs an ARP request by sending ARP request packets on both rings (the outer ring and the inner ring).
  • Upon receiving the ARP request, the responding node checks it’s topology map to determine which ring will be used for data packet transmission and which will be used for control packet transmission. Selection of the data transmission ring is based on the hop count metric. The ring with the smaller number of hops is selected for data transmission and the other ring is used to transmit control packets, including the ARP response.
  • The responding node sends the ARP response on the ring that will be used to control packet transfer. For example, if the responding node determines that the shortest hop between itself and the source is via the outer ring, the responding node will send the ARP response on the inner ring.
  • When the source node receives the ARP response, it notes the ring identifier where the ARP response is received and uses the opposite ring to send data packets.

The model also allows you to disable dynamic ring selection for a given node by configuring the node to use a specified ring for data transmission. To do this, use the node’s Ring Selection attribute.