Cyber Effects Control Flow
The execution of cyber effects during a simulation is controlled by the cyber-effects manager (CEM) module in each cyber-enabled node. At the beginning of a simulation, each CEM collects information about which effects its node can support.
If a node has a profile specified in its Cyber Effects attribute, that node’s CEM will send the scripts in the profile to the specified destinations at the specified times. The CEM of each destination node then executes the scripts it receives and sends a response, if one is needed. Scripts are sent via packets, so that attack and remedy communications between nodes will be affected by cyber effects the same way as other network traffic.
If a node contains a local script, the CEM executes that script directly on the node at the specified times rather than sending it to another node for execution.
Event Sequence
- At initialization (sim time 0.0):
- Each module in a node registers the effects it supports with the node’s CEM.
- Each CEM discovers the profile and script definitions from the Cyber Effects configuration node.
- Each CEM schedules events to start execution of its profiles and local scripts.
- When a profile is executed:
- Originating CEM sends script packets to the CEM in each destination node
- Destination CEMs execute scripts, sending commands to modules in the node
- Modules execute effects, optionally sending responses within the node to the CEM
- Destination CEMs send response packets to originating CEM as needed