SDN Switch Attributes

The important attributes for the SDN switch are described in this section. For specific information on configuring your SDN model, see Configuring SDN.

Figure 476: SDN Switch Attributes

SDN Switch Attributes

The following table lists a brief description of all parent attributes that pertain to the SDN modeling:

Table 197: SDN Switch Attributes

Attribute Description
Controller IP Address Specifies the IP address of the controller. You must configure this for the model to function properly.
Controller TCP Port Specifies the TCP port of the controller over which controller-to-switch communication takes place (i.e., the port the controller is listening on). Default: OpenFlow TCP Port.
Controller Connection Time Specifies the time when the switch will initiate its TCP connection with the controller. Default: 0.0 seconds.
Port to Controller Specifies the port number of the switch used for communication with the controller. This port must be configured in SDN Switch > Port Configuration, and it must be connected and active.
SDN Switch > Switch Configuration
Address Specifies the 48-bit MAC address that identifies this switch.
Number of Flow Tables Specifies the number of flow tables available on this switch.
Packet Service Rate Specifies the rate at which packets are switched from the switch processor to the output port.
QoS Parameters Compound attribute that specifies node-wide Layer-2 QoS attributes.
SDN Switch > Port Configuration Specifies the ports configured on the switch.