Using Route Reflectors

Route reflectors are also used to reduce the required number of IBGP connections. You can set up route reflectors in your network model by configuring a single compound attribute on each router that acts as a route reflector. No special configuration is required for routers that are not route reflectors.

Procedure 25: Configuring a Route Reflector

  1. Specify the Cluster ID supported by this route reflector in IP Routing Protocols > BGP Parameters > Instances > Global > Instance Properties > Cluster ID.

  2. Specify the neighbors that will be members of the client group by editing the IP Routing Protocols > BGP Parameters > Neighbors > Neighbor Properties attribute. You define the neighbor to set the Neighbor Properties attribute.

    Note: The local router becomes the route reflector when you specify neighbors as members of the client group.

  3. Enable or disable route reflection between clients in the IP Routing Protocols > BGP Parameters > Address Family Parameters > Address Family Properties > Client-to-Client Reflection attribute.

End of Procedure 25