Visualizing a Network Scenario in 3D Network Visualizer

Procedure 9 describes the procedure for viewing a network scenario in 3D Network Visualizer.

Note: If you experience any problems, see Appendix H “Troubleshooting 3D Network Visualizer and Logger“ on page 561.

Procedure 9: Viewing a Network Scenario in 3D Network Visualizer (Planning Mode)

  1. Modeler—Open the project and scenario that you want to visualize.

  2. Project Editor—Specify the terrain data to use in Modeler.

    Choose Topology > Terrain > Specify Terrain Data Directory… and specify the OpenFlight terrain data directory and file format. You can specify an explicit file as well as a directory.

    For more information about using terrain data, see Specifying Terrain Data.

  3. Windows Start menu—Choose Programs > OPNET 3D Network Visualizer 3.2.0 > 3DNV Communications 3.2.0. This starts the 3DNV Communications process that enables Modeler and 3D Network Visualizer to communicate.

  4. Windows Start menu—Choose Programs > OPNET 3D Network Visualizer 3.2.0> OPNET 3D Network Visualizer 3.2.0 (<rti>, <bitness>). Choose the program that matches the RTI type (DOD 1.3 or IEEE 1516) and operating system (32-bit or 64-bit) you are using. This starts the visualizer process.

    Note: You must have 3DNV Communications already running. Modeler and 3D Network Visualizer use this process to communicate.

  5. 3D Network Visualizer—Choose File > Open > Terrain… and select the appropriate OpenFlight terrain database (typically the same database you specified in step 2).

    Note: Depending on the size of the terrain database, this might take 1–2 minutes.

    For more information about using terrain data, see Specifying Terrain Data.

  6. Project Editor—Choose 3DNV > Display 3D Network View to enable the 3D network visualization.

  7. Project Editor—Choose View > Show Time Controller. This window enables you to step through the 3D node-movement animation.

  8. Project Editor—Use the Time Controller to step through the node-movement animation. For information about using the Time Controller, see “Show Time Controller“ on page 178.