Visualizing Path Loss in 3D Network Visualizer
You can visualize the radio path loss between two or more sites. This lets you see the effect of intervening terrain on communications between sites. Combined with trajectory visualization, you can see the effect terrain will have on radio transmissions between mobile sites.
Two preferences control how path loss is visualized:
- “3dnv.pathloss_center_frequency“ sets the center frequency (in megahertz) used to calculate path loss for display in 3D Network Visualizer.
- “3dnv.pathloss_bandwidth“ sets the bandwidth (in kilohertz) used to calculate path loss for display in 3D Network Visualizer.
Path loss can be visualized only for nodes that are mapped to a 3D Network Visualizer entity. Each path loss line is drawn from a node containing a radio transmitter module to a node containing a radio receiver module.
To view path loss in 3D Network Visualizer, follow Procedure 11.
Procedure 11: Viewing Path Loss in 3D Network Visualizer (Planning Mode)
-
Visualize a network scenario in 3D Network Visualizer (as described in Procedure 9).
-
Project Editor—Either follow Procedure 18 Managing Path Loss Visualization or do the following:
2.1 Select the nodes whose path loss you want to visualize.
Note: You must select at least two nodes, with a radio transmitter module in at least one node and a radio receiver module in at least one other node.
2.2 Choose 3DNV > Show Pathloss of Selected Nodes in 3D Visualizer.
2.3 After showing path loss for a group of nodes, you can change the nodes for which path loss is being displayed in several ways:
- Select a new group of nodes and choose 3DNV > Show Pathloss of Selected Nodes in 3D Visualizer again. (This will remove the path loss lines for the original group and display the path loss for the new group.)
- Hide the path loss of certain nodes by selecting them and choosing 3DNV > Hide Pathloss of Selected Nodes in 3D Visualizer.
- Show or hide path loss for an individual node by right-clicking it and toggling Display Pathloss in 3D Visualizer. (This operation is available only when path loss is already displayed for a group of nodes.)
-
Project Editor—If desired, choose View > Show Time Controller. You can use the Time Controller to view changes in path loss as mobile nodes move along their trajectories.