Specifying Terrain Data
To visualize a network scenario in 3D Network Visualizer, you must specify the terrain data used by Modeler and the Visualizer. The specified terrain data must correspond to the geographic area that you want to visualize. For best results, you should specify the same terrain data in both Modeler and the Visualizer.
Note: The 3D Animation Viewer requires terrain data in OpenFlight format. Although Modeler allows you to use other terrain formats (such as DTED and USGS DEM), it is strongly recommended that Modeler and 3D Network Visualizer use the same terrain database for consistent altitude information.
Procedure 5: Specifying Terrain Data for a 3D Animation (Planning Mode)
-
Install terrain data that corresponds to the geographic area of interest.
-
Specify terrain data to use in Modeler.
In the Project Editor, choose Topology > Terrain > Specify Terrain Data Directory and specify the terrain data directory and file format. If you are using OpenFlight data, you can specify an explicit file as well as a directory.
-
Specify the terrain data to use in 3D Network Visualizer.
Choose File > Open Database, and select the same OpenFlight terrain database used in the Modeler scenario.
Table 24: Using Terrain Data in Riverbed Modeler: References
| Topic | Reference |
|---|---|
| Obtaining terrain data | “How To Find and Install Terrain Data“ on page 4 |
| Specifying terrain data | Specifying Terrain Data on page TMM-2-3 |