Model Architecture: ZigBee
The following sections describe the underlying architecture of the ZigBee models.
All model files are included in the following directory, unless otherwise indicated:
<reldir>/models/std/zigbee
Node Model Architecture
The following figure depicts the architecture of the zigbee_station_adv node model. This architecture is used by the coordinator, router, and end device models.
Figure 685: ZigBee Coordinator, Router, and End Device Node Model Architecture

The following figure depicts the architecture of the zigbee_ipha_adv node model.
Figure 686: ZigBee IPHA Node Model Architecture

The following figure depicts the architecture of the zigbee_gwy_adv node model.
Figure 687: ZigBee Gateway Node Model Architecture

Process Models
The ZigBee model uses the following process models.
Table 278: ZigBee Process Models
| Process | Description |
|---|---|
| 802_15_4_mac | This process implements a model of the IEE 802.15.4-2003 MAC protocol. The model implements the channel scanning, joining, and failure / recovery procedures of the protocol, in the unslotted operation mode. |
| csma_ca | This process model implements the Carrier Sense Multiple Access/Collision Avoidance (CSMA/CA) function of the ZigBee MAC Layer. (This model is located in <reldir>/models/std/base.) |
| zigbee_application | This process model represents a low-fidelity version of the ZigBee Application Layer as specified in the 2006 ZigBee Specification. The process model initiates network joins and formations, generates and receives traffic, and generates the ZigBee “General Report at Simulation Time <x>”. |
| zigbee_network | This process model implements the ZigBee Network Layer as specified in the 2006 ZigBee specification. It is responsible for routing traffic, processing network join and formation requests, and generating beacons. |