Node Models: PNNI

Node models used for modeling PNNI configurations are the same as those used in modeling ATM networks. The PNNI Overload Config object, however, is a special utility node you can use to configure the point in the simulation at which switches go into and come out of an overload condition.

When a switch goes into an overload condition, it cannot accept any more PNNI information. In the operational network, it may happen due to memory limitations on the switch. In the model, the time at which the switch goes into the overload condition is explicitly specified. The switch can still process connection requests and switch data packets based on the PNNI routing information it has, but it will not be able to accept any new topology information. Once the switch goes out of the overload condition, it can process PNNI routing packets in the normal manner. The node model is shown in Figure 428

Figure 428: PNNI Overload Config Model

PNNI Overload Config Model

Note: For more information about ATM node models, see "Node Models: ATM" on page 5.