Configuring MANET Routing Protocols

When you have completed the configuration of your basic MANET network model, you must configure the routing protocols on both the nodes and the routers in the network. All available MANET routing protocols provide loop-free, shortest path routing.

Note: If you configured your network using the Wireless Network Deployment wizard, the ad hoc routing protocol you specified is configured on the nodes.

The following MANET routing protocols are modeled:

  • Ad Hoc On Demand Distance Vector (AODV)
  • Dynamic Source Routing (DSR)
  • Geographic Routing Protocol (GRP)
  • Optimized Link State Routing (OLSR)
  • Open Shortest Path First (OSPF) version 3
  • Temporally Ordered Routing Algorithm (TORA)

The following table lists and compares the available MANET routing protocols:

Table 154: Comparison of MANET Routing Protocols

DSR AODV OLSR TORA OSPFv3 GRP
Routing Philosophy Reactive Reactive Proactive Both proactive and reactive Proactive Proactive
Type of Routing Source routing Hop-by-hop routing Hop-by-hop routing Hop-by-hop routing Hop-by-hop routing Hop-by-hop routing
Frequency of Updates As needed As needed Periodically Based on mode of operation Periodically Periodically
Worst case Full flooding Full flooding Pure link state Full flooding Pure link state Full flooding
Multiple Routes Yes No No No Yes No

Host Configuration

Workstation and server nodes within a MANET must run a routing protocol that will allow them to find a route to other devices and to form an ad hoc network. Configure each node in the network to use one of the MANET routing protocols.

Figure 365: Configure Ad Hoc Routing Protocols on Node

Configure Ad Hoc Routing Protocols on Node

Router Configuration

Routers within a MANET must have the same MANET routing protocol configured on every router interface under IP > IP Routing Parameters > Interface Information > Routing Protocols, as shown in the following figure.

Figure 366: MANET Router Configuration on Interface

MANET Router Configuration on Interface

Simplified Multicast Forwarding Configuration

SMF can be configured on MANET interfaces using attributes in the AD-HOC Routing Parameters group, as shown in the following figure. Note that it is not enough to just enable the SMF Functionality attribute on a node. You must also make sure that the SMF Parameters > Interfaces attribute is configured for every interface that should use SMF.

Figure 367: Attributes for Configuring Simplified Multicast Forwarding

Attributes for Configuring Simplified Multicast Forwarding

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com