Viewing Animations
This section includes procedures you can use to control satellite animations.
Animating Satellite Orbits
Use this procedure to begin an animation of the satellite orbits.
Procedure 23: Animating Satellites
-
Verify that the Show attribute of the satellite (in the satellite data table) is on.
-
Modify the animation attributes by entering new values in the text entry areas. The attributes apply to the satellite animation as a whole, not to individual satellites. Animation attributes are described in Table 16.
-
Choose Tools > Animate Satellites or click the Animate button in the toolbar.
Figure 53: Animate Toolbar Button

The animation begins. Satellites move around their orbits based on the specified time parameters.
The following table describes animation attributes.
Table 16: Animation Attributes
| Attribute | Description |
|---|---|
| start time | The time (in seconds) at which the animation begins. |
| stop time | The time (in seconds) at which the animation ends. |
| frames per second | The number of images per second that will be displayed during animation (limited to the capabilities of the host computer). |
| time step | The amount of animation time which elapses between each frame. The higher the time step, the faster the animation sequence. The time step can be verified by monitoring the TIME item in the op_vuorb tool window. As the animation sequence progresses, the TIME item advances according to the specified time step (in increments of 100 seconds by default). |
Setting the Animation Start Time
This procedure lets you specify the time at which the animation begins. If you are interested in only a certain portion of an orbit, or want to see the location of the satellite at a certain point in the animation, set the start time to the time of interest.
Procedure 24: Setting a Start Time
-
Choose Tools > Set Start Time or click the Time button on the toolbar.
Figure 54: Time Toolbar Button

The current time dialog box pops up.
-
Enter the desired time. The time must be within the start and stop times indicated in the satellite data table.
The satellite is displayed at its orbital position for the specified time and the TIME label in the tool window is updated.
Pausing an Animation
When you pause an animation, you can resume it from the point at which it was stopped. You might want to pause an animation to perform any of the following operations:
- Changing the view.
- Changing the time.
- Changing satellite or animation attributes.
Procedure 25: Pausing an Animation
-
Do one of the following:
-
Click either the left or right mouse button.
The animation pauses at the current time.
-
Click the Animate button on the toolbar.
The animation pauses momentarily, then resumes.
-
Restarting an Animation
Paused animations can be restarted from the point at which they were paused.
Procedure 26: Restarting an Animation
-
Click the Animate button on the toolbar.
The animation continues from the pause point.