Editing an Intervisibility Object

You can change the following aspects of an intervisibility object:

  • Change the location of either end point of an intervisibility line, to change its length and direction.
  • Change the origin of an intervisibility fan, thereby moving the entire fan.
  • Change the diameter of an intervisibility fan.

Note: If an intervisibility object is anchored to an entity, you cannot change the origin.

Procedure 96: Changing the Length or Diameter of an Intervisibility Object

  1. To edit a line, double-click its end point. To edit a fan, select the object, then double-click the outer ring of the fan.

    The cursor changes (resize cursor).

  2. Drag the end point or circle towards or away from the origin. If you are editing an intervisibility line, you can move the end point to any location.

  3. Click to exit edit mode.

    Note: To revert to the original size of the intervisibility object, right-click while you are still in edit mode.

Procedure 97: Moving an Intervisibility Fan or Line

  1. Double-click a fan’s center point or any place on a line. The cursor changes.

  2. Drag the object to a new location.

  3. Click to set the location.

    Note: To revert to the original location of the intervisibility object, right-click while you are still in edit mode.