Physical Layer Features

Packet Loss Modeling

Two methods are available for modeling packet loss:

  • When physical layer modeling is enabled, the model accounts for packet losses that are caused by physical layer effects.
  • When the framing module is enabled, you can configure subscriber station nodes to drop a certain percentage of the PDUs for a given flow or connection.

Only one of these methods is used during a simulation. The WiMAX Efficiency Mode attribute determines which method is used.

PHY Layer Overhead and Impairment Modeling

The model includes the following physical (PHY) layer overhead and impairment modeling effects

  • Only TDD (Time Division Duplex) mode is supported
  • PHY-layer overheads
  • PHY profiles for SOFDMA (Scalable OFDMA) with 128, 512, 1024, and 2048 subcarriers
  • Co-channel interference for SOFDMA
  • Pathloss
  • Multipath fading for SOFDMA channels
  • Received power-based base station selection
  • STC 2x2, STC 2x1, Receiver Diversity 1x2, and SISO support on downlink and uplink channels

Partial Usage of Subchannels (PUSC)

PUSC segmentation is supported in the WiMAX model. PUSC segmentation allows you to divide subchannels into disjoint sets of subchannels, thereby reducing interference.

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com