Using the Default OSPF Configuration in a Model

To use the default mode, designate OSPF on appropriate router interfaces. See Chapter 14 “IP” on page 1 for detailed information about how to do this in IPv4. See Chapter 17 “IPv6” on page 1 for detailed information about how to do this in IPv6.

When you use the default OSPF configuration, you enable the following features:

  • Single OSPF Area. Areas are a primary means of minimizing overhead due to the routing protocol. They allow you to perform route aggregation whereby a single route is advertised to represent multiple destinations within an area. By default, route aggregation is not used and all routers belong to a single backbone area.
  • Single process. Processes let you run different OSPF configurations on different interfaces of the same node. By default, all OSPF interfaces run the same process, which has a process tag of “1.”
  • No statically determined neighbors. No neighbors are learned through a table instead of through a dynamic routing protocol.
  • No redistribution. By default, OSPF processes do not learn of routes from other processes, other dynamic protocols, or directly connected interfaces that are not running OSPF.