Importing an Existing OSPF Network
If you are modeling an existing OSPFv2 network, the easiest way to model the existing configuration in Riverbed Modeler, is to import the network topology from the device configuration files or from NetCollector. These methods let you bypass the manual configuration process. For information about using importing topologies, see the following:
- Device configuration import (DCI): See “Importing Topologies”
- Import from NetCollector See “Import from NetCollector”
When using OSPF, you can work with the protocol in a simple default mode, or configure it fully, in a manner closely resembling OSPF configuration on your actual network. The default mode lets you avoid configuring most of the OSPF-related attributes of your routers.
Note: Regardless of whether you use the default configuration or manually configure additional features, you will need to designate the interfaces of your routers that use the OSPF protocol, because by default, RIP (or RIPng for IPv6) is used on each router interface.