Model Features: IS-IS
This section lists the main features available in the Intermediate System-to-Intermediate System model suite.
The IS-IS model suite captures the following protocol behavior:
Table 127: IS-IS Model Features
| Model Feature | Description |
|---|---|
| Link state routing | Router node models running IS-IS build routing tables by obtaining link information from a global link-state database and by using Dijkstra’s algorithm to find the shortest path to every destination in the domain. |
| Multiple processes | A router can have multiple IS-IS routing processes active at the same time. When multiple processes are running, routing information is exchanged among the processes through redistribution. Multiple processes are supported for discrete event simulation, but not flow analysis. |
| IPv6 | A single IS-IS process can support both IPv4 and IPv6 routing. IS-IS can be configured to run on selected or all nodes in the network using the IPv6 routing protocol configuration wizard. |
| Two-level hierarchy | An IS-IS domain can have a two-level hierarchy with a single Level-2 area and multiple Level-1 areas. Routers in Level-1 areas exchange routing packets with other routers in the same Level-1 area. To communicate with a router in another area, data packets are sent to the nearest Level-2 router, which routes the packets at Level-2. |
| Traffic engineering | The IS-IS model supports Constraint Shortest Path First (CSPF) computations, which are used to set up MPLS Label Switched Paths (LSPs). When setting up an MPLS LSP, the MPLS module requests a CSPF path from IS-IS or OSPF. If both protocols are enabled, the IS-IS path is used. The IS-IS TE feature consists of: • Dissemination of TE attributes in IS-IS link state packets using TLVs • CSPF computations to determine a path for an LSP The CSPF computation using IS-IS TE considers • metrics such as TE metric, IS-IS metric and delay • TE attributes such as available link bandwidth • include and exclude colors (resource classes) |
| Virtual links | IS-IS allows automatic repair of partitioned Level-1 areas using a virtual link through level-2. A partitioned level-2 cannot be repaired. |
| Hello protocol | IS-IS routers establish neighbor relationships by exchanging periodic hello messages with neighbors. |
| Pseudo-nodes | To reduce the amount of routing information maintained in each router’s link-state database, IS-IS represents broadcast networks as pseudo-nodes (PSN), where each router connected to the broadcast network has a link to the PSN and the PSN has a link back to each router. |
| Metric configuration | The metric (interface cost) is specified as an absolute number or it can be auto-calculated based on the interface bandwidth. Standard 6-bit and wide 3-byte metrics are supported. For a single selected link, you can also configure asymmetric interface costs for IS-IS. |
| Failure recovery | The IS-IS model suite supports failure and recovery of nodes and links in the network. The model learns of failures and recoveries through interrupts and modifies the global link-state database accordingly. |
| Overload | A router can indicate to other routers that its LS database is full by setting an overload flag in its packets. This will cause other routers to avoid using the overloaded router in their routing table calculations. |
| Message Priority | You can set the priority of ISIS messages exchanged in the entire network by specifying the DSCP marking of the messages using the corresponding global attribute. The default value is CS6. |