Single-Band Jammer

The single-band jammer model can be deployed as a fixed, mobile, or satellite node in the Project Editor. This node model is called jam_sb. It provides continuous transmission on a single fixed frequency band by sending packets through a radio transmitter at the rate of 1 per second.

The following figure shows the internal structure of the single band jammer model.

Figure 124: jam_sb Node Model Diagram

jam_sb node model diagram

In addition to the built-in node object attributes, the attributes that can be controlled for a single-band jammer are:

  • Jammer band base frequency
  • Jammer bandwidth
  • Jammer bandwidth usage percentage
  • Jammer bandwidth band position
  • Jammer transmitter power

The following figure, taken from the Project Editor, shows the configurable attributes of the single-band jammer.

Figure 125: Single Band Jammer Attributes

Single band jammer attributes

The time duration of a jammer packet is equal to Jammer Packet Size / Jammer Data Rate.

The frequency information of a jammer packet is decided by the "Jammer Band Base Frequency", "Jammer Bandwidth", "Bandwidth Usage Percentage" and "Transmission Band Position" attributes.

Jammer Bandwidth Usage Percentage

In a typical cellular communication system, the entire bandwidth is not always in use; rather, it exhibits random peaks and valleys. When using jammer node models to model interference caused by a neighbor cell or a network of a different technology in the vicinity, you can set the "Jammer Bandwidth Usage Percentage" to reflect a realistic percentage of bandwidth utilized by jammer packet transmissions. Unless Bandwidth Utilization Percentage is set to "Full Bandwidth", transmissions may not always occupy the entire bandwidth. Instead they may occupy a fraction of entire bandwidth, which is decided by the distribution you set.

Jammer Bandwidth Band Position

Allows you to configure where exactly the jammer packet should be in the frequency axis.

  • When set to "Bottom", the jammer packets transmitted will have a minimum frequency equal to the band base frequency.
  • When set to "Top", the jammer packets transmitted will have the same maximum frequency which is the sum of "Jammer Band Base Frequency" and "Jammer Bandwidth" attribute values.

Jammer Transmission Band Position has the following allowable values: "Top", "Bottom", "Top or Bottom", or "Random". These values are illustrated in the figure below.

Figure 126: Jammer Bandwidth Band Position

Jammer bandwidth band position

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com