Configuring Your Computer to Run SITL
Before using SITL, you should prepare your computer for SITL simulations.
Procedure 2: Setting Up a Windows Computer for SITL
-
If a Transaction Analyzer Application Capture Agent is running on the computer, stop it before using SITL.
-
(Optional, but recommended to simplify debugging) Turn off unneeded network components to reduce background traffic noise:
2.1 Open the Network and Dial-up Connections control panel.
2.2 Right-click on Local Area Connection and choose Properties from the pop-up menu.
2.3 Note which components are selected (so you can restore them when finished running SITL simulations).
2.4 Unselect every component except Internet Protocol (TCP/IP), then click OK.
2.5 Disable NetBIOS:
- Select Internet Protocol (TCP/IP).
- Click Properties. This opens the Internet Protocol (TCP/IP) Properties dialog box.
- Click Advanced. This opens the Advanced TCP/IP Settings dialog box.
- Select the WINs tab and select the "Disable NetBIOS over TCP/IP" option.
- Click OK in the Advanced TCP/IP Settings dialog box and the Internet Protocol (TCP/IP) Properties dialog box.
2.6 Close the Network and Dial-up Connections control panel.
-
(Optional, but strongly recommended) Configure a firewall on your SITL computer to block any traffic the simulation will be handling. This will prevent the computer and the simulation from both responding to an incoming packet.
Note: Avoid using a firewall (such as ZoneAlarm) that blocks packets before WinPcap sees them.
Procedure 3: Setting Up a Linux Computer for SITL
-
If a Transaction Analyzer Application Capture Agent is running on the computer, stop it before using SITL.
-
(Optional, but strongly recommended) Configure a firewall on your SITL computer to block any traffic the simulation will be handling. This will prevent the computer and the simulation from both responding to an incoming packet.
Note: Avoid using a firewall that blocks packets before libpcap sees them.