Visualizing a Network Simulation in 3D Network Visualizer (Simulation Mode)

Procedure 19 describes the procedure for visualizing a simulation. This procedure assumes you have already configured the network and simulation as described in Network Simulation Workflow Using Modeler and 3D Network Visualizer.

Note: If you experience any problems viewing the animation, see Appendix H “Troubleshooting 3D Network Visualizer and Logger“ on page 561.

Procedure 19: Visualizing a Network Simulation in 3D Network Visualizer (Simulation Mode)

  1. Modeler—Open the project and scenario that you want to visualize.

    If you were already viewing an animation for the scenario in planning mode, choose 3DNV > Display 3D Network View to stop the planning animation.

  2. Windows Start menu—Choose Programs > OPNET 3D Network Visualizer 3.2.0> 3DNV Communications 3.2.0. This starts a 3DNV Communications process that enables Modeler and 3D Network Visualizer to communicate.

  3. If you want to visualize a cosimulation that includes any external HLA federates, you must use Run-Time Infrastructures (RTIs) that support these federates. If you need to run any additional RTIs, start them now.

  4. Windows Start menu—Choose Programs > OPNET 3D Network Visualizer 3.2.0> OPNET 3D Network Visualizer 3.2.0 (<rti>, <bitness>). Choose the program that matches the RTI type (DOD 1.3 or IEEE 1516) and operating system (32-bit or 64-bit) you are using. This starts the visualizer process.

    Note: You must have 3DNV Communications already running.

  5. 3D Network Visualizer—Choose File > Open > Terrain…, then select the appropriate OpenFlight terrain database (typically the same as used in the Modeler scenario).

  6. Modeler Project Editor—Choose DES > Configure/Run Discrete Event Simulation and verify that the simulation is configured as described in Configuring and Running Simulations for 3D Animations.

  7. Click Run in the Configure/Run Discrete Event Simulation dialog box.

    The simulation starts.

  8. As the simulation progresses, 3D Network Visualizer window visualizes the network state at the simulation time.