Configuring Link Aggregation on Switches
This section describes how to configure link aggregation on a switch node. For basic configuration, you can enable link aggregation in a network by enabling LACP on the switch ports connected to the links that you want to aggregate. This is done by setting the Switch Port Configuration > Port Grouping Parameters > Aggregation Protocol attribute to LACP. With this configuration, LACP will automatically detect group names and use a default distribution algorithm.
Procedure 74: Configuring Link Aggregation on Switches
- Enable LACP on port interfaces. The ports attached to the links that will be aggregated need to have LACP enabled. To do this, set the Switch Port Configuration > Port Grouping Parameters > Aggregation Protocol attribute to LACP for each port.
- Set up switch port groups. The switches in the network can be configured with one or more groups, which are used by LACP when bundling links. The groups are defined and configured in the Switch Port Group Configuration attribute on the switch. A group must be defined in this attribute to be available to the individual ports.
- Set the Port Grouping Parameters. The ports connected to links that are to be bundled need to be configured to belong to the same group. The Switch Port Configuration > Port Grouping Parameters > Group Name attribute lets you specify a group name configured in the previous step. The group specifications on either side of the link do not need to match, the model forms aggregated links from the smallest common groupings.
- Optionally, set the distribution algorithm. The distribution algorithm is set in the Switch Port Group Configuration > Distribution Algorithm attribute.
End of Procedure 74